The project
...I know, its very bad, this is why I usually dont make draws
Start making the brass pieces
Unfortunately Ive lost some photos of the "making of"...
anyway the procedure was basically the same of the "manettinodellabenza": file, sandpaper and polish
This is the finished choke lever
(Ive made some changes from the initial draw...)
This is the finished choke lever
(Ive made some changes from the initial draw...)
And the idle control knob
New 7075 aluminium engine supports
Fitting Preview
Making the two splitted screws and bolts
Fitting test
Finally all in place
Ill polish it better later
Choke on / Choke off
